Operator's Manual

7
Setup
Note: Use this chart as a checklist to ensure that all parts have been received. Without these parts, total setup cannot be
completed.
Description Qty. Use
Castor wheel
Axle
Washer
Cotter pin
2
2
8
4
Mount castor wheels to castor forks
Drive shaft 1 Mount drive shaft blower and tractor
Operator’s Manual 1 Read before operating the machine.
Parts Catalog 1
Note: Determine the left and right sides of the machine
from the normal operating position.
Ballast Requirements
Without the proper amount of ballast in the tires,
the tractor may become unstable and cause bodily
injury.
Make sure that the front of the tractor is equipped
with the proper amount of ballast; refer to the
tractor operator’s manual for ballast
requirements.
Caution
Reposition Control Handle
1. Remove (2) carriage bolts, washers and nuts securing
control handle to control lever (Fig. 1).
1
2
Figure 1
1. Control handle 2. Control lever
2. Rotate control handle upward and re–secure to control
lever with fasteners removed. Handle grip to point away
from blower.
1
2
Figure 2
1. Control handle 2. Control lever