Operator's Manual

10
1
2
Figure 5
1. Jack 2. Pin
3. Adjust jack height until blower frame is parallel with
the ground.
4. Insert hitch tube into frame tube (Fig. 6). Secure tube to
frame with a clevis pin and hair pin cotter.
1
2
Figure 6
1. Hitch tube 2. Frame tube
5. Back tow vehicle up to blower.
6. Adjust blower hitch clevis to same level as tractor hitch
as follows:
• Remove bolts and locknuts securing hitch clevis
(Fig. 7) to hitch tube.
1
2
Figure 7
1. Hitch clevis 2. Hitch tube
• Raise or lower hitch clevis to position
approximately level with tow vehicle hitch.
• Secure with bolts and locknuts previously removed.
7. Remove clevis pin and hair pin cotter securing hitch
tube to frame tube (Fig. 8).
1
2
3
4
Figure 8
1. Hitch tube
2. Frame tube
3. Hitch clevis
4. Jack –storage position
8. Adjust hitch tube length to assure blower does not
contact tow vehicle when turning.
9. Secure with clevis pin and hair pin cotter.
10. Connect tow vehicle hitch to debris blower clevis hitch
with hitch pin and clevis.
11. Remove jack pin, rotate jack upward and reconnect to
frame pin for storage.