Operator's Manual

7
Specifications
General Specifications
General Description
An upper mid sized debris blower with self–contained power. It is compactly packaged and
easily towed by most utility vehicles. The fan can be lowered for highly effective air
delivery at turf level or raised for transport.
Frame One piece welded steel frame with greasable pivot points
Suspension 1500 lb. Torflex axle. 5–bolt, 4.5 inch bolt circle hubs
Wheels and Tires Stamped and welded steel wheels. Titan Turf Trac tires 20 x 10.00–8, 4 ply.
Hitch Telescoping for various towing accommodations. Adjustable for various hitch heights.
Motor
23 HP Kohler Command Pro V–Twin electric start, air cooled, gas engine. Full pressure
lubricated, oil filter and 4 pint cap. 15 amp. alternator. Screened air intake. Remote electric
solenoid throttle control.
Fuel Tank Capacity is 7 gallons
Fan Impeller
.250 HRPO plate
Radial design with 8 blades
Outer diameter 24 inches + .5 inch
Width 6 1/2 inches + 1–1/4 inch
Weight 45 lbs. + 2 lbs.
Fan Housing
Split house – upper housing and lower housing
Upper housing – 12 ga. HRPO front and rear plates flanged at separation seam with 12 ga.
HRPO rolled and flanged blower band with increasing radius from cutoff point
Lower housing – 10 ga. HRPO front and rear plates flanged at separation seam with 12 ga.
HRPO roller and flanged blower band with increasing radius to exhaust
Inside housing clearance 7 inches + 1/4 inch
Fan Speed 2000 RPM + 50 RPM
Outlet Area 70 square inches
Fan Output
6500 CFM + 500 CFM
155 MPH + 20 MPH
Directional Control
Deflector chute for 180 degree diversion as standard. Remotely controlled with an electric
actuator
Turf Protection Skid plate
Drive
Belt drive 4–3VX
Drive ratio: 1.78:1
Love joy torsion type belt tightener
Weight: 730 lbs. + 50 lbs.
Note: Specifications and design subject to change without notice.