Service Manual
Table Of Contents
- Title Page
- Revision History
- Reader Comments
- Preface
- Table Of Contents
- 1 - Safety
- 2 - Product Records and Maintenance
- 3 - Engine
- Kohler Engine Service Manual
- 4 - Electrical System
- General Information
- Electrical Diagrams
- Special Tools
- Troubleshooting
- Electrical System Quick Checks
- Component Testing
- Ignition Switch
- Hour Meter
- Fuse
- Fusible Link
- Relays
- Remote Transmitter (Machines with Single Channel Controller
- Remote Transmitter (Machines with Multi Channel Controller)
- Wireless Control Module (Machines with Single Channel Controller)
- Wireless Control Module (Machines with Multi Channel Controller)
- Diode Assembly (Serial Number Below 310000000)
- Service and Repairs
- 5 - Blower Assembly
- 6 - Chassis
- 7 - Electrical Diagrams
- Electrical Schematic Model 44538 (S/N Below 310000000)
- Electrical Schematic Models 44538 and 44539 (S/N From 310000000 to 311999999) and Model 44542
- Electrical Schematic Models 44538 and 44539 (S/N Above 312000000)
- Engine Electrical Diagram (S/N Below 310000000)
- Engine Electrical Diagram (S/N Above 310000000)
- Control Module Wake Up
- Crank Circuits
- Run Circuits
- Engine Speed Increase Circuits
- Nozzle Rotation Circuits
- Wire Harness Drawing Model 44538 (S/N Below 310000000)
- Wire Harness Diagram Model 44538 (S/N Below 310000000)
- Wire Harness Drawing Models 44538 and 44539 (S/N 310000000 to 311999999) and Model 44542
- Wire Harness Diagram Models 44538 and 44539 (S/N 310000000 to 311999999) and Model 44542
- Wire Harness Drawing Models 44538 and 44539 (S/N Above 312000000)
- Wire Harness Diagram Models 44538 and 44539 (S/N Above 312000000)
ProForce Debris BlowerPage 5 -- 4Blower Assembly
Service and Repairs
Blower Drive Shaft
1. Flange nut
2. Fan hub
3. Cap screw
4. Spacer
5. Spacer
6. Flat washer
7. Cap screw
8. Drive coupling
9. Flat washer
10. Cap screw
11. Woodruff key
12. Drive shaft
13. Engine hub and coupling assembly
Figure 2
FRONT
RIGHT
6
7
3
2
5
4
8
9
10
12
13
3
5
9
10
11
1
1
4
1
9
1
11
Loctite #242
300 to 330 in--lb
(34to37N--m)
300 to 330 in--lb
(34to37N--m)
NOTE: The c oupling assembly between the blower
shaft and drive shaft (item 12) is illustrated in Figure 2.
The coupling assembly (item 13) used between the
drive shaft (item 12) and engine shaft is composed of the
same components (Fig. 3).