Service Manual
Table Of Contents
- Title Page
- Revision History
- Reader Comments
- Preface
- Table Of Contents
- 1 - Safety
- 2 - Product Records and Maintenance
- 3 - Engine
- Kohler Engine Service Manual
- 4 - Electrical System
- General Information
- Electrical Diagrams
- Special Tools
- Troubleshooting
- Electrical System Quick Checks
- Component Testing
- Ignition Switch
- Hour Meter
- Fuse
- Fusible Link
- Relays
- Remote Transmitter (Machines with Single Channel Controller
- Remote Transmitter (Machines with Multi Channel Controller)
- Wireless Control Module (Machines with Single Channel Controller)
- Wireless Control Module (Machines with Multi Channel Controller)
- Diode Assembly (Serial Number Below 310000000)
- Service and Repairs
- 5 - Blower Assembly
- 6 - Chassis
- 7 - Electrical Diagrams
- Electrical Schematic Model 44538 (S/N Below 310000000)
- Electrical Schematic Models 44538 and 44539 (S/N From 310000000 to 311999999) and Model 44542
- Electrical Schematic Models 44538 and 44539 (S/N Above 312000000)
- Engine Electrical Diagram (S/N Below 310000000)
- Engine Electrical Diagram (S/N Above 310000000)
- Control Module Wake Up
- Crank Circuits
- Run Circuits
- Engine Speed Increase Circuits
- Nozzle Rotation Circuits
- Wire Harness Drawing Model 44538 (S/N Below 310000000)
- Wire Harness Diagram Model 44538 (S/N Below 310000000)
- Wire Harness Drawing Models 44538 and 44539 (S/N 310000000 to 311999999) and Model 44542
- Wire Harness Diagram Models 44538 and 44539 (S/N 310000000 to 311999999) and Model 44542
- Wire Harness Drawing Models 44538 and 44539 (S/N Above 312000000)
- Wire Harness Diagram Models 44538 and 44539 (S/N Above 312000000)
ProForce Debris Blower
Page 4 -- 20
Electrical System
Service and Repairs
NOTE: See the Kohler Engine Service Manual (in-
cluded at the end of Chapter 3 -- Engine) for engine elec-
trical component repair information.
Nozzle Motor
1. Nozzle
2. Nozzle clamp
3. V belt
4. Housing assembly
5. Flat washer (10 used)
6. R--clamp
7. Nozzle motor
8. Motor bracket
9. Cap screw (3 used)
10. Drive pulley
11. Lock nut
12. Cap screw (2 used)
13. Belt guard
14. Flange head screw (2 used)
15. Flat washer
16. Cap screw
17. Flange nut (2 used)
18. Flange nut
19. Leaf spring
20. Bearing
21. Cap screw (2 used)
22. Flange nut (2 used)
23. Shoulder bolt
24. Lock nut
25. Nozzle pulley
26. Nozzle guide
Figure 25
FRONT
RIGHT
1
3
2
6
4
15
16
18
20
7
8
9
10
11
12
13
14
17
19
20
21
22
23
15
5
24
16
20
25
26
NOTE: If nozzle motor wear or damage occurs, motor
replacement is necessary. Individual components for
the nozzle motor are not available.