Operator's Manual

Page 16
10. Using the work vehicle’s lift cylinder, raise the front
of the ProPass until the front storage stand legs are
off the ground.
11. Remove the two front storage stand legs and store
them.
12. Lower the front of the ProPass onto the frame rails of
the work vehicle.
13. Turn off the engine.
14. Connect the electrical power connection to the work
vehicle, see Figure 9.
Figure 9: Electrical connection on work vehicle
15. Connect the ProPass hydraulic lines to the work
vehicle’s hydraulic connections (at the rear; see
Figure 10). The line with the one-way flow check
valve connects to the return connection on the work
vehicle.
Figure 10: Hydraulic connections
How to Remove a Truck Mount ProPass
from the Storage Stand
1. Park the work vehicle in the storage spot for the
ProPass.
2. Disconnect the electrical connection from the work
vehicle (Figure 9).
3. Disconnect the ProPass hydraulic lines from the
work vehicle (Figure 10).
4. With the work vehicle in neutral gear, set the parking
brake and start the engine.
5. Using the vehicle lift cylinder, raise the front of the
ProPass high enough for the front storage stand legs.
6. Turn off the engine.
7. Insert the front and rear storage stand legs and secure
them with locking pins.
8. With the work vehicle in neutral gear, set the parking
brake and start the engine.
9. Using the vehicle lift cylinder, lower the front of the
ProPass until the front storage stand legs begin to
touch the ground.
10. Turn off the engine.
11. Raise the two rear storage jack stands until the
pressure is off the rear mounting pins.