Operator's Manual

Page 17
12. Remove the rear mounting pins.
13. With one hand, hold the lift cylinder. With the other
hand, remove the lift cylinder’s locking pin.
14. Rest the lift cylinder in the appropriate location on
the work vehicle’s frame.
15. Walk around the ProPass. Ensure that it is clear of
the work vehicle’s frame and secured within each of
the four storage stand legs.
16. With the work vehicle in neutral gear, set the parking
brake and start the engine.
17. Release the parking brake and slowly drive the work
vehicle forward, away from the ProPass truck-mount
on the storage stand (Figure 7).
WARNING: Do not climb under or
perform work on the ProPass while it is
on the storage stand.