Operator's Manual

Page 22
Standard Hydraulic Control
WARNING: Before operating the
ProPass, read and understand the entire
Operator’s Manual and all safety decals.
Figure 11: Floor Control Valve
Flow Control Valve for Floor
A hydraulic flow control valve controls the speed of the
conveyor belt. It is color-coded to match the Color-Coded
Operation System decals found on the spinner housing.
The highest speed setting is 10 and is typical for most
applications found on the Color-Coded Operation System
decals. Use lower settings for very light applications.
Flow Control Valve for Options
Figure 12: Option Control Valve
A hydraulic flow control valve controls the speed of the
option (Twin Spinner). The SPINNER icon indicates the
speed percentage for the WIRELESS controller ONLY –
for STANDARD hydraulics, place the control in the
appropriate color area, starting at the dotted line and
adjust speeds within the color zone as required.
WARNING: Do not leave the ProPass
unattended while it is running.
On / Off Pendant
Use the two switches on the on/off pendant to run the
conveyor belt or the option (Figure 13). The on/off
pendant should be kept within reach of the operator.
Figure 13: On/off pendant
How to Operate the ProPass
1. Fill the ProPass hopper with the material to be spread
as mentioned above.
2. Ensure option is installed (Twin Spinner).
3. Adjust the gate height to the preferred setting. (See
the ProPass Factory-Recommended Settings Guide
in this manual).
4. Adjust both flow control valves to the preferred
setting. On Wireless models set the belt and option
speeds to the preferred setting.