Operator's Manual

Page 30
TO OPERATE IN PRESET MODE:
1) Ensure hydraulic flow is off
2) POWER ON
the WIRELESS
CONTROLLER
3) Press the
, OR – FLOOR
and SPINNER settings will be displayed
4) Press
to STORE to WORKING
MODE
5) Press
to exit
6) Ensure hydraulic flow is active
7) As you approach the area requiring topdressing
press
to SELECT the SPINNERS
8) Press
to ENGAGE the SPINNERS.
9) When you are ready to spread material, press
to SELECT the FLOOR
10) Press
to ENGAGE the FLOOR.
11) When you wish to stop spreading, press
to stop the flow of material.
12) To begin spreading again, press
to ENGAGE.
If you wish to START all functions at once:
1) Press , OR
2) Press
to SELECT the FLOOR and the
SPINNERS.
1) Press
to ENGAGE the FLOOR and the
SPINNERS.
If you wish to STOP all functions at once:
1) Press to DISENGAGE the FLOOR and
the SPINNER.
NOTE: With ALL START, the SPINNER starts first and
after a brief delay, the FLOOR engages. When ALL
STOP is pressed, the FLOOR stops first followed by the
SPINNERS.
CHANGING PRESET WHILE IDLE:
You can change between PRESETS either at idle or
while operating.
1) Press
, OR – FLOOR and
SPINNER settings will be displayed
2) Press
to ACTIVATE
3) Press
to STORE to WORKING MODE
(hydraulics will engage)
CAUTION: When changing or saving
PRESETS while idle, the ProPass will activate
if there is any hydraulic flow. While adjusting
PRESETS be sure to stay clear of moving
parts and press ALL STOP to complete.