Service Manual

ProPass 200 Page 5 -- 7 Chassis
Disassembly (Fig. 3)
1. Position machine on a levelsurface.IfProPassisat-
tached to tow vehicle, apply tow vehicle parking brake,
stop engine and remove key from the ignition switch.
Chock wheels to prevent ProPass machine from mov-
ing.
2. Remove guard cap and RH drive guard from frame
to allow access to floor drive components (Fig. 4).
3. Loosen cap screw and lock nut that secure idler
sprocket (item 5) to frame. Move idler sprocket to re-
move tension from drive chain.
4. Locate and remove master link (item 16) from drive
chain. Note direction of master link clip for assembly pur-
poses. Remove drive chain.
5. Loosen set screws (item 15) that secure sprocket to
shaft of drive roller. Slide sprocket from shaft. Remove
square key ( item 13) from shaft.
NOTE: If floor motor (item 2) needs to be removed, see
Floor Motor in the Service and Repairs section of
Chapter 3 -- Hydraulic System.
Assembly (Fig. 3)
1. Apply antiseize lubricant to drive roller shaft.
2. Position square key to slot in drive roller shaft and
then slide sprocket (item 3) onto shaft.
3. Fit drive chain onto floor motor sprocket, drive roller
sprocket and idler sprocket. Install master link (item 16)
to drive chain and secure ends with master link clip.
Make sure that the closed end of the master link clip is
facing the direction of chain rotation.
NOTE: Direction o f normal roller rotation is shown in
Figure 5 as viewed f rom right side of conveyor.
4. Check that chain is aligned to sprockets. I f alignment
adjustment is necessary, move sprocket on drive roller
shaft as needed.
5. Apply Loctite #242 (or equivalent) to threads of set
screws (item 15). Tighten set screws to secure sprocket
to drive roller shaft.
6. Move idler sprocket (item 5) to tension the drive
chain. Secure idler sprocket by tightening cap screw
and lock nut. A properly adjusted chain should allow for
free rotation of drive components.
7. Secure RH drive guard and guard cap to frame (Fig.
4).
1. Guard cap
2. Cap screw (3 used)
3. RH drive guard
4. Cap screw (2 used)
5. Flat washer (2 used)
6. Lanyard (2 used)
7. Shoulder nut (2 used)
8. Rivet (2 used)
9. Screw retainer
Figure 4
9
8
7
2
3
4
1
6
5
2
2
1. Drive roller
2. Idler roller
3. RH conveyor frame
4. Rotation direction
Figure 5
2
4
1
43
FRONT
Chassis