Service Manual

ProPass 200 Page 2 -- 1 Product Records and Maintenance
Chapter 2
Product Records and Maintenance
Table of Contents
PRODUCT RECORDS 1.........................
MAINTENANCE 1..............................
EQUIVALENTS AND CONVERSIONS 2...........
Decimal and Millimeter Equivalents 2............
U.S. to Metric Conversions 2...................
TORQUE SPECIFICATIONS 3...................
Fastener Identification 3.......................
Using a Torque Wrench with an Offset Wrench 3..
Standard Torque for Dry, Zinc Plated and
Steel Fasteners (Inch Series) 4...............
Standard Torque for Dry, Zinc Plated and
Steel Fasteners (Metric Fasteners) 5..........
Other Torque Specifications 6..................
Conversion Factors 6.........................
Product R ecords
Insert Operator’s Manuals and Parts Catalog for your
ProPass at the end of this chapter. Additionally, insert
Installation Instructions, Operator’s Manuals and Parts
Catalogs for any accessories that have been installed
on your ProPass at the end of this section.
Maintenance
Maintenance procedures and recommended service in-
tervals for your ProPass are covered in the Operator’s
Manual. Refer to this publications when performing reg-
ular equipment maintenance. Several maintenance pro-
cedures have break--in intervals identified in the
Operator’s Manuals. If machine is equipped with the hy-
draulic power pack, refer to the Engine Owner’s Manual
for additional engine specific maintenance procedures.
Product Records
and Maintenance