Service Manual

ProPass 200 Page 3 -- 13 Hydraulic System

Hydraulic Schematic

ProPass 200

All solenoids are shown as

de--energized

Electronic Hydraulic Controls

FLOOR

MOTOR

HYDRAULIC

SPINNER

MOTORS

CONTROL

MANIFOLD

POWER PACK

FA FB LA LB O T1

CV1 CV2 CV3 CV4

SP1

ORF1

EC1

ORF2

ORF3

ORF4

(0.040)

(0.020)

(0.068)

(0.020)

SV1

PV1

S2 S1 S2 S1

PLUGPLUG

CONVEYOR

MOTOR

NOTE: The hydraulic schematic shown above includes

the hydraulic power pack as the hydraulic supply

source. If your ProPass uses hydraulic supply from the

tow vehicle, the vehicle includes the hydraulic pump, re-

lief valve and hydraulic reservoir t hat are used for the

ProPass.

NOTE: The rear option is either the twin spinner (two

motors) or the cross conveyor (one motor).

NOTE: The hydraulic hose kit used when a ProPass re-

ceives its hydraulic supply from a tow vehicle includes

acheckvalveinthereturnhoseassembly(seeHydraul-

ic Hose Kit in the General Information section of this

chapter).

Hydraulic

System