Service Manual

ManualsBrandsToro ManualsTop DressersProPass 200 Top Dresser with Twin Spinner and Wireless Control

ProPass 200Page 3 -- 30Hydraulic System

Control Valve Service (Machines with Standard Hydraulic Controls)

ProPass machines with standard hydraulic controls use

two (2) control valves for adjusting the speed of the floor

and rear option (twin spinner or conveyor) motors.

These control valves are located on the front of the hop-

per (Fig. 29).

NOTE: See Hydraulic Control (Machines with Standard

Hydraulic Controls) in this section for information on re-

moving the control valve from the machine.

Disassembly (Fig. 30)

NOTE: A seal kit is available for the control valve. If

wear or damage exists to the control valve body, side

lever or compensator spool, control valve assembly re-

placement is necessary.

1. Loosen set screw and slide handle from side lever.

2. Remove retaining rings that secure side lever in the

control valve body.

3. Slide seal retainers from side lever.

4. Pull side lever from control valve body. Remove

O--rings from side lever.

5. Remove plugs from control valve body. Slide com-

pensator spring and spool from body.

6. Clean control valve components.

7. Inspect side lever, compensator spool and control

valve body for wear or damage. Replace control valve

assembly if damage exists to these components.

Assembly (Fig. 30)

1. Lubricate new seal kit components with clean hy-

draulic oil and install new O--rings on side lever and

plugs.

2. Dip compensator spool and side lever into clean hy-

draulic oil.

3. Install plug into the control valve body port opposite

the bore for the compensator spool. Then, slide lubric-

ated compensator spool into body. Insert spring and in-

stall second plug into control valve body.

4. Slide lubricated side lever into control valve body. Fit

seal retainer and retaining ring to both ends of side lever

to secure side lever in control valve body.

5. Slide handle into side lever and secure with set

screw.

Figure 29

1. Floor control valve 2. Option control valve

Figure 30

1. Body

2. Set screw

3. Handle

4. Retaining ring

5. Seal retainer

6. O--ring

7. O--ring

8. Side lever

9. Plug with O--ring

10. Compensator spring

11. Compensator spool