Setup Instructions

Page 10
Figure 30: Installing right side shield
18. Install 6.4 x 25.4 mm (1/4 x 1 in) Button head bolts,
washers and nylon lock nuts in the middle and front
mounting holes. Refer to Figure 31.
Figure 31: Installing Button head bolts
19. Route the option hoses through the rear of the right
side shield of the Truck Mount Kit and down to the
option. Refer to Figure 32.
Figure 32: Routing option hoses
CAUTION: Do not raise the ProPass
with the Workman hydraulic lift
cylinders when an option is attached to
the ProPass.
20. Lift the front of the ProPass up as high as possible
using the lift cylinder. Install the lift cylinder safety
brace as per the instructions in the Workman owner's
manual.
21. Identify the return hose (marked with a flow
direction decal) and the pressure hose included with
the Toro Workman Truck Mount. These are shown
in the parts manual.
22. Connect the hoses to the ProPass as shown in Figure
21. Wireless ProPasss refer to Figure 22.
23. Route the hydraulic pressure and return hoses along
the right side of the ProPass. Clamp the hoses in
place using three hose clamps on the Workman truck
mount front, center and rear cross members. Use 6.4
x 63.5 mm (1/4 x 2-1/2 in) bolts, two hydraulic line
clamps, one clamp plate, washers and a nylon lock
nut. Refer to Figure 33, Figure 34, and Figure 35.