Setup Instructions

Page 13
John Deere ProGator Truck
Mount Configuration
1. Remove the cargo box from the John Deere
ProGator. Refer to the ProGator owner's manual.
2. Install the rear cross member onto the rear pivot
using the existing pins. Refer to Figure 37.
Figure 37: Installing rear cross member
3. Install the center cross member to the lift cylinder
using the John Deere lift cylinder pin. Refer to
Figure 38.
Figure 38: Installing center cross member
4. Take note of the inner brace tube, one is the left side
and one will be the right side. Refer to Figure 39 and
Figure 40.
Figure 39: Inner brace tubes
Figure 40: Inner brace tubes (close-up)
5. Install both left and right inner brace tubes to the
inside of the rear cross member brackets. Refer to
Figure 41.