Setup Instructions

Page 23
Figure 67: Clamp the swivel to the ProPass
5. Check the clearance of the Adjustable Belt Guard to
the ProPass main conveyor belt. If the gap between
the belt and the Adjustable guard (Figure 68 [shown
with belt scraper removed] black arrow) is greater
than ¼” (6.35mm), loosen the four ¼” (6.35mm)
bolts on the Adjustable Guard (Figure 68 arrows)
and slide the guard until it is spaced approximately
¼” (6.35mm) from the ProPass main conveyor belt.
Figure 68: ProPass conveyor belt with clearance
6. Pin the conveyor in the “travel position” with the
motor on the right hand side of the ProPass (Figure
69). Connect the hoses as shown in Figure 70 (note
the conveyor has been moved from its travel position
for clarity of hose routing).
Figure 69: Conveyor pinned in the travel position
Figure 70: Conveyor hose routing