Setup Instructions

Page 7
Figure 22: Installing Hoses on ProPass Wireless
22. Install the Pendant Plug into the four prong harness
connector at the front of the ProPass. On Wireless
ProPass, plug the control pendant into the control
pendant lead on the ProPass then route the wire to
the end of the pressure and return hose using the
black spiral wrap included with the Wireless base
model.
23. Connect the ProPass to the tow vehicle using a
standard rated tow pin. Refer to the Operators
Manual.
24. Connect the pressure and return hydraulic lines from
the ProPass to the tow vehicle. The tow vehicle must
have 22.7 L/min (6 Gal/min) of hydraulic oil flow at
138 Bar (2000 PSI) to operate the ProPass.
25. Attach the male power plug to the female plug on the
rear of your tow vehicle.
Return
Pressure