Operator's Manual

Page 19
For filling aerification holes, simply adjust all settings
to RED.
ULTRA HEAVY
Approx. Width: 9'
Blade Position: B
Floor Speed: 100%
Spinner Speed: Red / 15%
Tailgate: Red
Slide Adjustment: Red
TAILGATE
The TAILGATE controls the
VOLUME of material that flows from
the ProPass. The 5" tailgate is divided
into colors with a target starting line in
each color section.
You can increase or decrease the
amount of material with the tailgate as
long as you stay within the
corresponding color section.
SPINNER SPEED
Standard Hydraulics: Set
the hydraulic control to the
dotted start line in the
corresponding color area. You can vary the speeds if
required within the corresponding color section.
Wireless control: Set
according to the percentage
indicated in the colored
section of the decal and on
the chart on the back of the
wireless controller.
SLIDE ADJUSTMENT
The SLIDE ADJUSTMENT
provides ideal positioning of the sand as it falls onto the
discs. The decal not only indicates the color coded start
position for each application, it illustrates the adjustment
required to fine tune your spread. (see step 4 below)
FLOOR SPEED
The floor speed for every setting is 100% - this was
developed and tested in order to have one less factor to
adjust in the Color-Coded Operating System.
NOTE: Use the tailgate to reduce material volume. If the
minimum tailgate height is insufficient to reduce material
flow, then decrease floor speed.