Operator's Manual

Page 27
11) Press to confirm your settings for
WORKING MODE
The CONTROLLER is now set to operate at these
settings. If the unit is powered off, these settings will be
recalled automatically when powered back on.
WORKING MODE WITH ALL START:
You can also save both of your adjusted settings together.
1) Press
to view both current saved settings
on the LCD display
2) Set your
and to
desired percentages
3) Press
to STORE
4) Press
to exit
5) Press
to confirm your settings for
WORKING MODE
Keep in mind, the WIRELESS CONTROLLER will return
to its last saved default setting after 10 seconds if no
buttons are touched.
TO OPERATE IN WORKING MODE:
1) Ensure hydraulic flow is active
2) POWER ON
the WIRELESS
CONTROLLER
3) Press
to SELECT the SPINNERS, press
again to ENGAGE the SPINNERS.
4) The LCD display will indicate when the
SPINNERS have reached their target speed
percentage.
5) When you are ready to spread material, press
to SELECT the FLOOR and then
again to ENGAGE the FLOOR.
6) When you wish to STOP spreading, press
to stop the flow of material.
7) To begin spreading again, press
to SELECT and ENGAGE the FLOOR.
8) When you are finished topdressing press
to stop the FLOOR then
to stop the
SPINNERS.
If you wish to START all functions at once:
1) Press to SELECT the FLOOR and the
SPINNER and confirm the settings
2) Press
to ENGAGE the FLOOR and the
SPINNER
NOTE: With ALL START, the SPINNER starts first and
after a brief delay, the FLOOR engages.
If you wish to STOP all functions at once:
1) Press to DISENGAGE the FLOOR and
the SPINNER.