Setup Instructions

Page 8

Toro Workman Truck Mount

Configuration

1. Remove the cargo box from the Toro Workman.

Refer to the Workman owner's manual.

2. Install both the left and the right side inner brace

tubes to the rear cross member brackets with two

spacers using 9.5 x 63.5 mm (3/8 x 2-1/2 in) bolts,

washers on both sides and nylon lock nuts. Leave the

bolts loose at this time. Refer to Figure 23.

Figure 23: Installing inner brace tubes

3. Install the center cross member to the left and right

side inner brace tubes using 9.5 x 44.5 mm (3/8 x 1-

3/4 in) bolts, two washers and nylon lock nuts. Leave

the bolts loose at this time. Refer to Figure 24.

Figure 24: Installing center cross member

4. Install the rear cross member onto the two rear pivot

points using the provided pins and two to three

washers on the inside of the cross member bracket

and on the outside of the Toro frame rail. Refer to

Figure 25. This will keep the Toro mount assembly

centered.

Figure 25: Installing rear cross member

MPORTANT: Check and ensure that there is proper

clearance between the center cross member and the

Toro’s rear fenders and the oil filter assembly.

5. Install both the left and right lift cylinder arms to the

center cross member using the existing pins and

locking pins. Refer to Figure 26.

Figure 26: Installing lift cylinder arms

Note: When installing the four pivot pins, ensure that

the locking pins are installed and completely latched.

Note: It may be necessary to move the hydraulic lift

cylinder forward or backward until the pivot pins

line up with the mounting holes.

6. Ensure that the center cross member is square to the

rear cross member.