Setup Instructions

Page 20
How to Install the Electrical
Connection Kit
The electrical connection kit provides the electrical
power required by the control systems of the ProPass.
The kit should be installed on the vehicle that will be
used to operate the ProPass. If more than one vehicle will
be used to operate the ProPass, additional electrical
connection kits can be purchased from your local
distributor.
The electrical connection kit is primarily designed to be
installed on a John Deere ProGator or a Toro Workman
truck, however, the kit can also be easily installed on
many other tow-vehicles.
To install the connection kit:
11. Mount the electrical plug bracket to a fixed point at
the rear of the tow vehicle using one of the two
mounting brackets provided. Refer to Figure 59.
Note: Ensure that the bracket will not come in
contact with anything if the tow vehicle is equipped
with a dump box.
Figure 59: Mounting electrical plug bracket
12. Route and secure the electrical wiring from the
battery to the electrical plug bracket.
Figure 60: Electrical socket wiring and bracket
13. Feed the wiring through the electrical plug bracket,
install the black rubber grommet over the wiring and
then connect the wiring to the electrical socket. Refer
to
14. Figure 60.
15. Bolt the socket to the electrical plug bracket using
the 6.4 mm (¼ in) bolts supplied with the kit.
16. Connect the red wire (power) to the positive post on
the battery, then connect the black wire (ground) to
the negative post on the battery.
IMPORTANT: Ensure that none of the wiring is
loose or in the way of any mechanical
components.