Setup Instructions

Page 1
Note: Throughout this manual, the terms “left” and
“right” are used. When you stand behind the ProPass
facing towards the rear of it, your left side corresponds to
the left side of the ProPass.
Initial ProPass Base Model
Setup
1. Remove the Base Model ProPass from the shipping
crate.
2. Remove the 6.4 x 19.1 mm (¼ x ¾ in) bolt and nut
attaching the ProPass lifting device shipping bracket
with the Twin Spinner (located at the rear of the
Twin Spinner). Refer to Figure 1.
Figure 1: Removing shipping bracket
3. Remove the two 6.4 x 19.1 mm (¼ x ¾ in) bolts and
nuts attaching the ProPass lifting device shipping
bracket with the Twin Spinner (located at the front of
the Twin Spinner). Refer to Figure 2.
Figure 2: Removing shipping bracket
4. This step requires two people. Lift the Twin Spinner
out of the hopper using the outer grab handles of the
Twin Spinner. Place the Twin Spinner unit on the
ground. Refer to Figure 3.
Figure 3: Removing Twin Spinner from hopper
5. Remove the woodscrew from the upper Twin
Spinner guard. Remove the 9.5 mm (3/8 in) wood
from the guard. Refer to Figure 4.