Setup Instructions

Page 2
Figure 4: Removing wood from Twin Spinner guard
6. Remove the four screws from the legs of the Twin
Spinner. With the help of a partner, lift the Twin
Spinner and remove the packing studs and packing
foam. Refer to Figure 5
Figure 5: Removing packing studs and foam
7. Install the hopper guard using the supplied 6.4 x 15.9
mm (1/4 x 5/8 in) button head bolts, washers, and
nylon lock nuts (Figure 6 ).
Figure 6: Front view of the hopper front guard
8. Attach a lifting device to the lifting bracket bolted
inside the hopper assembly. Refer to Figure 7.
Figure 7: Lifting ProPass from shipping crate
Note: Retain the lifting bracket for future use. Do
not discard.
WARNING: Do not attempt to lift the
bed and hopper with the Tow-Behind
Chassis, ProGator, Workman or TDC
Chassis connected. The lifting bracket is
not capable of lifting the entire machine.
9. Lift the bed and hopper assembly from the crate and
lower it onto the selected chassis. Refer to Figure 8.
10. Remove the lifting bracket from the inside of the
hopper assembly. Reinstall the bolts to the hopper
sides.
Figure 8: Lowering ProPass onto chassis
11. Install the Electric Connection Kit to the tow vehicle
designated to be used with the ProPass.