Setup Instructions

Page 5
Figure 14: Fenders Installed
7. Torque the fender bolts to 13.8 kg-m (100 ft-
lbs).
8. Install the fender brackets with two 9.5mm
(3/8”) bolts with flat washers and nylon lock
nuts, see Figure 15.
Figure 15: Fender Bracket Installed
**Note: If you are planning to install a Honda
Engine Power Pack on your Tow Chassis,
disregard Step 9 and proceed to Step 10.
9. Attach the left and right side rear support gussets
on the rear of your Tow Chassis using the four
9.5mm (3/8”) bolts with the included flat
washers and nylon lock nuts. Torque these bolts
to 45 ft-lbs.
**Note: The left side rear gusset has a small
dimple in the triangular cut out to help
distinguish it from the right side gusset, see
Figure 16.
Figure 16: Left Side Gusset Has Dimple
10. The hitch tube is heavy so assistance may be
required. For ease of installation, attach the jack to
the hitch tube via the jack ring on the side of the
hitch tube.
11. With the jack positioned perpendicular to the hitch
tube, crank it up to its maximum stroke. Place the
jack foot firmly on the ground and have your
assistant install the hitch channel into the front brace
assembly.
**Note: The jack should be on the left side of the
machine, and the gusset on the end of the hitch
should be on the underside, see arrow Figure
17.
Figure 17: Jack Perpendicular to Hitch Tube