Operator's Manual

Page 12
CAUTION: Ensure that all control
systems are turned off when working on
the Power Pack.
Setup Instructions
An authorized TORO Distributor normally sets up the
ProPass Top Dresser at the time of purchase. See the Setup
Manual for details.
This section covers only how to install the Twin Spinner
option.
Installation of the Twin Spinner
1. Remove the holding straps from the option.
2. To lift the option:
• Lift the Twin Spinner using the support handles on
each side (Figure 5).
CAUTION: For safety, use two people to
lift the Twin Spinner. It weighs 68 kg
(150 lb).
Figure 5: Twin Spinner
3. Slide the option onto the flanges of the side rails (at
the rear of the ProPass), lining up the mounting
guides on each side.
4. Lock the option into place with the locking
clamps on each side.
5. Adjust the locking clamps until the clamps are
just firm when closing (See Figure 6).
Figure 6: Locking clamps for Twin Spinner
6. Install the safety pins on the Twin Spinner option.
7. Connect the option’s hydraulic couplers to the
ProPass hydraulic couplers.
11HP Hydraulic Power Pack
Before starting the Honda engine, read the engine owner’s
manual.
1. Check that the oil drain port is tight and
completely fill the hydraulic tank with ISO VG-
68 hydraulic fluid—about 32.9 L (8.7 U.S. gal).
See the chart in this manual for recommended
hydraulic fluids.
I
MPORTANT: The hydraulic system will not completely
fill with fluid until the system is powered up. The
hydraulic fluid must therefore be checked and topped
up after initial running.
2. Connect the clevis hitch of the ProPass to the tow
vehicle. Use a high-strength hitch pin approved
for tow vehicles.
3. Check the engine’s oil level and fill if required.
See the engine owner’s manual.
4. Fill the fuel tank. Use unleaded fuel with an
octane rating no less than 87.