Operator's Manual

Page 24
Wireless Control
When finished working with the ProPass, always press
the E-Stop button (see Figure 14) to disable the electrical
system. When beginning work with the ProPass you must
pull the E-Stop button back out before turning on the
controller.
Figure 14: E-Stop Button
To Power On
Press the controller’s On/Off button and wait for the
controller to find the base. Ensure that there are no
buttons being pressed on the pendant while it is
performing its start-up routine.
Manual Override
Should the controller ever be lost, damaged or fail the
ProPass functions and operation are still possible in order
to complete tasks or continue work until the problem is
resolved.
The override access is on the driver side of the hydraulic
system. (see Figure 15)
Figure 15: Manual Override
To adjust the floor, turn the black knob clockwise.
Maximum floor speed is used in the Color-Coded
Operating System so this adjustment can be made while
no hydraulic flow is present. This is most relevant when
you have a hopper full of sand.
Figure 16: Manual Override Decal
To adjust the spinner speed, use a flat-head screwdriver
to increase by turning clockwise or decrease by turning
counter-clockwise.
If adjusting with hydraulic flow active, ensure the
FLOOR is turned off if you do not wish to have sand
being spread as you adjust.
Once your settings are acceptable, use the hydraulic flow
control on your tow vehicle to turn the system on and off
for operation.
NOTE: Do not use the manual override while operating
with the 11hp engine option. The hydraulic flow is
constant and there is no safe on/off capability. Use the
manual override for stationary operation only.