Operator's Manual

Page 29
PRESET MODE
The WIRELESS CONTROLLER comes with 3 PRESET
buttons that allow you to STORE commonly used or
recently adjusted settings for use in WORKING MODE.
For example: ‘1’ may be an Light setting for frequent
topdressing, ‘2’ may be a Medium setting and ‘3’ may be
a Heavy setting.
Use your PRESET buttons to suit your course conditions,
maintenance practices and topdressing program.
PROGRAMMING THE PRESETS:
1) Connect the ProPass to the electrical power – do
not engage hydraulic flow
2) POWER ON
the WIRELESS
CONTROLLER
3) Select
to view current saved setting
4) Adjust SPINNER
to desired
setting
5) Press
to ACTIVATE
6) Select
to view current saved setting
7) Adjust the FLOOR
to desired
setting
8) Press
to ACTIVATE
9) Press and hold
and ONE of the PRESET
numbers
, OR
10) Press
to exit
Repeat this process for each PRESET number as
required.
STORING WORKING MODE TO PRESET:
If you are in WORKING MODE and your ProPass is
IDLE, you can add the current settings to one of the
PRESET buttons.
1) Press
to view both settings
2) Press
again to ACTIVATE (hydraulics
will engage)
3) Press and hold
and ONE of the PRESET
numbers
, OR
4) Press
to exit (hydraulics will stop)
CAUTION: When SAVING changes to your
adjustments, the ProPass will activate if there
is any hydraulic flow. While adjusting or
SAVING be sure to stay clear of moving parts
and press STOP to complete.