Setup Instructions

Page 11

Figure 33: Routing hydraulic hoses

Figure 34: Hydraulic line clamps

MPORTANT: When routing either the hydraulic hoses

or the electrical wiring harness always remember to

route them out of the way of all moving components

and always ensure that there is no stress on the line.

This may require loosening and repositioning the

hydraulic hose at the front bulkhead. Refer to Figure

35.

Figure 35: Route hydraulic hose away from

other components

24. Between the front and center hose clamp ensure that

the hose bends upwards to clear the Workman’s

engine. To do this, install a cable tie around the

pressure and return hoses and attach it to one of the

ProPass’ side rail mounting holes. When attaching

the hose, ensure that there is proper tension on the

hoses. Refer to Figure 36.

Figure 36: Ensure proper tension of hydraulic hoses

25. Route and connect the male electrical power plug to

the Electrical Connection Kit.

Note: If the electrical connection kit is installed at

the rear of the tow vehicle, route and secure the

electrical power cord to the hydraulic pressure and

return hoses from the front to the rear of the ProPass.

26. Remove the lift cylinder safety bar and lower the

ProPass back down onto the chassis of the Workman.

27. Insert the pressure and return hoses into the proper

hydraulic port at the rear of the Workman.

28. Install the option and connect the hydraulic hoses to

the ProPass.