Setup Instructions

Page 16
Figure 49: Routing Twin Spinner hoses
18. Lift the front of the ProPass up as high as possible
using the lift cylinder. Install the lift cylinder safety
brace as per instructions in the ProGator owner's
manual.
CAUTION: Do not raise the ProPass
with the ProGator hydraulic lift cylinder
when an option is attached to the
ProPass.
19. Identify the return hose (marked with a flow
direction decal) and the pressure hose included with
the John Deere ProGator Truck Mount. These are
shown in the parts manual.
20. On the ProPass connect the hoses as shown in
Figure 21. For Wireless ProPass, refer to Figure 22.
21. Route both hydraulic pressure and return hoses
underneath the ProPass between the ProGator Truck
Mount cross members and the bottom of the ProPass.
Refer to Figure 50.
Figure 50: Routing hydraulic hoses
I
MPORTANT: When routing either the hydraulic hoses
or the electrical wiring harness always remember to
route them out of the way of all moving components
and always ensure that there is never any stress on the
line.
22. Attach the hydraulic pressure hose and the return
hose to the hose clamp provided at the rear of the
ProPass. When attaching the hose, ensure that that
there is proper tension on the hoses. Refer to Figure
51.
Figure 51: Attaching hydraulic hoses
23. Route and connect the male electrical power plug to
the Electrical Connection Kit. Note: If the electrical
connection kit is installed at the rear of the tow
vehicle, route and secure the electrical power cord to
the hydraulic pressure and return hoses from the
front to the rear of the ProPass.