Setup Instructions

Page 17
24. Remove the lift cylinder safety bar and lower the
ProPass back down onto the chassis of the ProGator.
25. Insert the pressure and return hoses into the proper
hydraulic port at the rear of the ProGator.
26. Install the option and connect the hydraulic hoses to
the ProPass.
NOTE:
When truck mounting a Wireless ProPass,
install the 45 degree elbow into the hydraulic block
for the tow-vehicle hydraulic pressure hose.
27. Connect, and then place the on/off control box into
the cab of the tow vehicle.
28. Remove the lifting bracket from the inside of the
hopper assembly. Reinstall the bolts in the hopper
assembly.
Your ProPass is now ready for operation. Refer to the
Operator’s Manual before operating.