Operator's Manual

Page 15
7. On tow-behind chassis turn the jack stand 90 degrees
(clockwise) to the down position to support the
ProPass.
8. On Truckster direct connect chassis move the jack
stands to the front of the machine and turn them
90 degrees until the bottom of both jack stands points
to the ground.
9. Lift the ProPass with the jack stand(s) until the
weight is off the tow vehicle’s draw bar. Pull out the
hitch pin.
10. Ensure that there is no further connection between
the ProPass and the tow vehicle.
How to Install a Truck Mount ProPass
from the Storage Stand
1. With the vehicle in neutral gear and the parking
brake set, start the work vehicle’s engine.
2. Release the parking brake, look over your left
shoulder, and slowly reverse the work vehicle
towards the ProPass truck-mount on the storage
stand (Figure 7).
Figure 7: Installing the ProPass onto the work vehicle
(or uninstalling it onto the storage stand)
3. Stop when the left rear mounting bracket on the
frame rail of the work vehicle is located directly
under and between the mounting bracket arms at the
left rear of the ProPass (Figure 8).
Figure 8: Mounting brackets at ProPass rear
4. Turn off the engine and set the parking brake.
5. Lower each of the two rear storage jack stands until
the holes in the mounting bracket align with the
holes in the work vehicle’s frame rail.
6. Insert the mounting pin and the safety pin, first at
one rear corner, then the other. If necessary, move
the storage stand legs to correctly align with the rear
mounting bracket holes.
7. Lower the rear storage jack stands. Remove and store
them.
CAUTION: Do not operate the ProPass
with the storage stand installed.
8. With one hand, lift and position the lift cylinder.
With the other hand, insert the existing locking pin.
(If necessary, start the work vehicle, then gently raise
or lower the lift cylinder until the hole in the
connecting arm of the cylinder aligns with the hole in
the ProPass mounting bracket.)
CAUTION: Keep your hands and feet
away from the engine when it is
running.
9. With the work vehicle in neutral gear and the parking
brake set, start the engine.