Operator's Manual

Page 28
ADJUSTING THE SETTINGS
Adjustments can be made while the ProPass is in
operation or when the ProPass is at idle. Any changes
you make to the settings on the WIRELESS
CONTROLLER can be SAVED and will become your
new WORKING MODE.
If you make a change to the settings, and do not SAVE
them, the WIRELESS CONTROLLER will default back
to the last saved setting.
TO SAVE SPINNER SPEED WHILE IDLE:
1) Press to view current saved setting on
LCD display
2) Set
to desired percentage
3) Press
to STORE the setting
(hydraulics will activate)
4) Press
to exit settings (hydraulics will
stop)
TO SAVE FLOOR SPEED WHILE IDLE:
1) Press to view current saved setting on
LCD display
2) Set
to desired percentage
3) Press
to STORE the setting
(hydraulics will activate)
4) Press
to exit OPTION settings
(hydraulics will stop)
ADJUSTING DURING OPERATION:
You can make settings adjustments as the ProPass is
operating by increasing or decreasing the FLOOR or
SPINNER speeds and observing the results directly. If
you make a change to the settings and do not SAVE
them, the WIRELESS CONTROLLER will default back
to the last saved WORKING MODE. Any settings made
while the ProPass is in OPERATION will remain active
until SAVED or STOPPED.
TO SAVE SPINNER SPEED WHILE
OPERATING:
1) Set to desired percentage
2) Press
to STORE the setting
TO SAVE FLOOR SPEED WHILE
OPERATING:
1) Set to desired percentage
2) Press
to STORE the setting
CAUTION: When SAVING changes to your
adjustments, the ProPass will activate if there
is any hydraulic flow. While adjusting or
SAVING be sure to stay clear of moving parts
and press STOP to complete.