Operator's Manual

Page 33
Belt and Rear Gate Seals
o Check all rubber seals for wear or damage. Replace
or repair the seals if any leakage occurs.
o Check and adjust the conveyor belt cleaning scraper.
Ensure the scraper is in full contact with the belt
across its length.
Options
o Check the blades on the Twin Spinner discs for wear.
Replace when they wear thin.
o Check the Twin Spinner housing for signs of
cracking or corrosion. Replace wear plates as
required.
o Check that the safety decals are undamaged and
legible, otherwise, replace them.
Wireless Controller
Install or Replace the Batteries
1. Place the Remote face down and remove the four
screws holding the battery cover in place. Remove
the battery cover.
Note: The four screws holding the battery cover in
place are ‘captive’ to the cover—the cover holes are
threaded. Although they are not easily removed from
the cover itself, be aware that the screws if over-
loosened while opening the battery compartment can
be completely removed increasing the risk of loss.
2. Remove the discharged batteries and properly
dispose in accordance with local regulations.
3. Plug each fresh battery into a terminal cradle
observing proper polarity. (If the batteries are
improperly installed, the unit will not be damaged,
but it will fail to operate.) The cradle is embossed
with polarity markings for each terminal—
emphasized in Figure 18. Make sure they are
firmly seated in the unit.
4. Replace the battery cover. Secure the cover with
the four screws. Make sure they are tightened
enough to compress the seal, but be careful not to
over-tighten.
Figure 18: Battery Compartment
+
+
—
—
—
—
+
+