Operator's Manual

Page 37
12. Inspect the hopper, bottom guard, conveyor belt,
bed, and rollers to ensure that all trapped
material is gone.
13. Lower the ProPass back into the normal
operating position.
14. Re-install the belt cleaning scraper assembly.
Push the scraper mount bar onto the belt. Ensure
that the scraper is as vertical as possible, but still
in contact with the belt.
Long-term Storage of the ProPass
Before storing the ProPass for the season:
1. Thoroughly clean the ProPass. Remove parts if
necessary.
2. Remove the control pendant.
3. Check all fasteners and tighten if necessary.
4. Grease all fittings and pivot points. Wipe off any
excess lubricant.
5. Apply a “never seize” product to the idler roller
and the drive roller shafts.
6. Lightly sand any painted areas that are
scratched, chipped, or rusted, and apply touch-
up paint.
Store the ProPass indoors if possible