Setup Instructions

Page 9
7. Ensure that the center cross member and the rear
cross member are sitting level. Refer to Figure 27.
Figure 27: Center and rear cross member sitting level
8. Tighten both the left and right inner brace tube bolts.
9. Recheck that the center cross member and the rear
cross member are sitting level and are square.
10. Install the front cross member on the frame of the
Workman 76.2 cm (30 in) in front of the center cross
member, arms facing forward.
11. Using the temporary lifting device, lift the ProPass
up high enough to back the Workman underneath.
12. Lower the ProPass down onto the Workman and line
up the center holes on the left side rail that measure
107.3cm (42-1/4in) from the front. Refer to Figure
28.
Figure 28: Lowering ProPass onto Workman
13. Install the 7.9 x 69.9 mm (5/16 x 2-3/4 in) bolts (left
side only) then install the 7.9 x 25.4 mm (5/16 x 1 in)
bolts (right side only). Fasten the bolts on both sides
with washers and nylon lock nuts. Refer to Figure
29.
14. Place the 7.9 x 25.4 mm (5/16 x 1 in) bolts (two on
each side) through the rear cross member and the
ProPass. Fasten the bolts with washers and nylon
lock nuts.
Figure 29: Installing bolts
15. Lift the ProPass up 5 cm (2 in), using the hydraulic
lift cylinders of the Toro Workman, to install the
front cross member. Place the 7.9 x 69.9 mm (5/16 x
2-3/4 in) bolts (two each side) through the front cross
member and the designated two holes on the ProPass
side rail. Fasten the bolts with washers and nylon
lock nuts.
16. Install the left side shield to the left side of the truck
mount kit using 6.4 x 15.9 mm (1/4 x 5/8 in) Button
head bolts and flat washers for the rear mounting
holes. Install 6.4 x 25.4 mm (1/4 x 1 in) Button head
bolts, washers and nylon lock nuts in the middle and
front mounting holes.
17. Install the right side shield to the right side of the
Truck Mount Kit using one 6.4 x 15.9 mm (1/4 x 5/8
in) regular bolt and washer and one 6.4 x 15.9 mm
(1/4 x 5/8 in) Button head bolt and flat washer for the
rear mounting holes. Refer to Figure 30.