Setup Instructions

Page 14
Figure 41: Installing brace tubes
6. Install both the left and right front inner brace tubes
to the brackets on the center cross members leaving
the bolts loose. Refer to Figure 42 and Figure 43.
Figure 42: Installing braces to brackets
Figure 43: Installing braces on center cross member
7. Ensure that the center cross member is square to the
rear cross member.
8. Ensure that the center cross member and the rear
cross member are sitting level.
9. Tighten both the left and the right inner brace tube
assembly bolts.
10. Check to ensure that there are ten mounting holes on
the left side mounting channel and nine holes on the
right side mounting channel of the ProPass.
I
MPORTANT: It may be necessary to move the
hydraulic lift cylinder forward until the bolt holes for
the inner cross member line up.
11. Using the temporary lifting device, lift the ProPass
up high enough to back the ProGator underneath.
12. Lower the ProPass down onto the ProGator and line
up the middle holes that measure 67.9 cm (26-3/4
in) from the front of each side rail of the ProPass
with the holes of the center cross member. Refer to
Figure 44.
Figure 44: Mounting ProPass onto ProGator
13. Install the 7.9 x 76.2 mm (5/16 x 3 in) bolts (in 6
locations), and fasten them using washers and nylon
lock nuts. Refer to Figure 45.