Setup Instructions

Page 15
Figure 45: Installing bolts
14. Lift the ProPass 5 cm (2 in) to install the front cross
member. Place the 7.9 x 76.2 mm (5/16 x 3 in) bolts
(two on each side) through the front cross member
and the ProPass. Fasten the bolts using washers and
nylon lock nuts. Refer to Figure 46.
Figure 46: Installing front cross member
15. Install the right side shield to the right side of the
truck mount kit using 6.4 x 15.9 mm (1/4 x 5/8 in)
stainless steel button head bolts and flat washers in
the rear mounting holes. Install 6.4 x 19.1 mm (1/4 x
¾ in) stainless steel button head bolts, washers and
nylon lock nuts in the middle and front mounting
holes. Refer to Figure 47.
Figure 47: Installing right side shield
16. Install the left side shield to the left side of the Truck
Mount Kit using 6.4 x 15.9 mm (1/4 x 5/8 in)
stainless steel button head bolts and flat washers in
the rear mounting holes. Install the 6.4 x 19.1 mm
(1/4 x ¾ in) stainless steel button head bolts, washers
and nylon lock nuts in the middle and front mounting
holes. Refer to Figure 48.
Figure 48: Installing left side shield
17. Route the Twin Spinner option hoses through the
rear of the right side cover on the truck mount kit and
down to the Twin Spinner. Refer to Figure 49.