Installation Instructions

ManualsBrandsToro ManualsTop DressersStorage Stand, ProPass 200 Top Dresser

FormNo.3365-549RevB

StorageStand

ProPass-200TopDresser

ModelNo.44712

InstallationInstructions

Installation

1.Parktheworkvehicleinthestoragespotforthe

ProPass.

Note:Thestoragespotmustbeahardandlevel

surface.

2.Disconnecttheelectricalconnectionfromthework

vehicle.

3.DisconnecttheProPasshydrauliclinesfromthe

workvehicle.

4.Withtheworkvehicleinneutralgear,settheparking

brakeandstarttheengine.

5.Usingthevehicleliftcylinder,raisethefrontofthe

ProPasshighenoughtoinstallthefrontstorage

standlegs.

6.Turnofftheengine.

WARNING

Donotclimbunderorperformworkonthe

ProPasswhileitisonthestoragestand.

7.Insertthefrontstoragelegsandtherearjackstands

intotheProPasstubesandsecurethemwiththe

lockingpins(

Figure1).

G014216

Figure1

1.Rearjackstands3.Lockingpin

2.Frontstoragelegs

8.Usingthevehicleliftcylinder,lowerthefrontofthe

ProPassuntilthefrontstoragestandlegsbeginto

touchtheground.

9.Raisethetworearstoragejackstandsuntilthe

pressureisoffthemountingpinsthatsecurethe

ProPasscrosstubetotheWorkmanframe.

10.Removetherearlynchpins,hitchpinsandwashers

(

Figure2).

Figure2

1.Hitchpin,washers&lynchpin

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

Summary of content (2 pages)

PAGE 1
Form No. 3365-549 Rev B Storage Stand ProPass-200 Top Dresser Model No. 44712 Installation Instructions Installation 1. Park the work vehicle in the storage spot for the ProPass. Note: The storage spot must be a hard and level surface. 2. Disconnect the electrical connection from the work vehicle. 3. Disconnect the ProPass hydraulic lines from the work vehicle. 4. With the work vehicle in neutral gear, set the parking brake and start the engine. 5.
PAGE 2
11. With one hand, hold the lift cylinder. With the other hand, remove the lift cylinder’s locking pin (Figure 3). Figure 3 1. Lift cylinder locking pin 12. Store the cylinders in the storage clips. Engage the hydraulic lift lock lever on the vehicle to prevent accidental extension of the lift cylinders. 13. Raise the rear jack stands until enough clearance is attained to drive the vehicle away from the ProPass. 14. Walk around the ProPass.