Installation Instructions

g031582
Figure5
Batteryharness(optional)
1.Switch-harnessconnector3.Positiveterminal(redwire)
2.Fuse
4.Groundterminal(black
wire)
2.Connectthegroundingterminaltotheground
blockofthevehicle.
3.Plugtheopenconnector(theswitch-harness
connector)onthepowerharnessintotheopen
connector(thepower-harnessconnector)onthe
switchharness.
4.Securetheharnesswithcableties,awayfrom
anysharpedges.
InstallingtheVibrator
1.Drill4mountingholes(7mmor9/32inch)on
thesideofthehopper.RefertoFigure6forthe
drillingdimensions.
Note:Locate1hole,thenusethemounting
plateasatemplatefordrillingtheremaining
holes.
g031584
Figure6
1.32.1cm(12-5/8inches)4.9.1cm(3-5/8inches)
2.4.1cm(1-5/8inches)5.11.3cm(4-7/16inches)
3.Hole(7mmor9/32inch)
2.Securethemountingplateandthevibratorto
thehopperusing4carriageboltsand4nutsas
showninFigure7.
Note:Positionthevibratorsothatthecableis
facingdown.
g024368
Figure7
1.Carriagebolt(4)
3.Vibrator
2.Mountingplate
4.Nut(4)
3.Connectthevibratorharnesstothevibrator.
g031585
Figure8
Vibratorharness
1.Switch-harnessconnector
2.Vibratorconnector
4.Connecttheswitchharnesstotheotherendof
thevibratorharness.
Note:Onatow-behindmachine,youcanmake
theconnectionwhenattachingthetopdresser
tothetractionunit.
5.Securetheharnesswithcableties,awayfrom
anysharpedges.
InstallingtheKitonan
MH-400MaterialHandler
InstallingtheSwitchHarnessand
theSwitchonaTractor
Note:Layouttheharnessesonthemachineto
determinethemountinglocationsoftheharness
components.Usetheincludedcabletiestoretainany
surpluscable.Also,ifyouneedtoshortenorlengthen
aharnesssection,usetheincludedwiresplices.Heat
theintegratedheat-shrinktubinguntilitshrinkstight
ontothewires.
Important:Ifyoulengthentheharness,make
suretousethepropergaugeofwire.
1.Routethewiringharnessthroughthetractor.
Note:Makesurethattheswitchharnesshas
enoughlengthtoreachthevibratorharness.
3