Form No. 3351–741 Sand Blade 240 Model No. 44900—Serial No.
Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Before Operating . . . . . . . . . . . . . . . . . . . . . . . . . . While Operating . . . . . . . . . . . . . . . . . . . . . . . . . . . Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Setup . . . . . . . . . . . . . . . . . . . . . . .
Safety • Check the safety interlock system daily for proper operation. If the switch should malfunction, replace the switch before operating machine. After every two years, replace the interlock switch in the safety system, whether it is working properly or not. This machine was designed and tested to offer safe service when operated and maintained properly.
• If the machine ever vibrates abnormally, stop immediately, turn the engine off, wait for all motion to stop, and inspect for damage. Repair all damage before commencing operation. • Before disconnecting or performing any work on the hydraulic system, all pressure in the system must be relieved by stopping the engine, engaging the parking brake, and lowering the attachments to the ground.
Setup Note: Determine the left and right sides of the machine from the normal operating position. Loose Parts Note: Use this chart as a checklist to ensure that all parts necessary for assembly have been shipped. If any of these parts are missing, total setup cannot be completed. Description Qty. Use R.H. Mount Arm L.H. Mount Arm Bold, 1/2” x 1–1/4” Lock Washer, .509 I.D. Nut, 1/2” 1 1 4 4 4 Mount to Sand Pro R.H Lift Arm Bolt, 5/8” x 4–1/2” Pivot Spacer Nut, 5/8” 1 2 1 2 Mount to mount arm L.
Install Blade to Sand Pro (Fig. 1) 3. Secure the right lift arm to the right mount arm with a 5/8” x 4–1/2” bolt, pivot spacer and nut. Tighten bolt only enough to allow arm to pivot. Note: When mounting the Sand Blade to a Sand Pro 5000/5020, a Mounting Kit, Model 44901 must be obtained and installed prior to the installation of the blade. Proceed to step 3 after installing the kit. 4. Secure the left lift arm to the left mount arm with a 5/8” x 4–1/2” bolt, flat washer and nut.
Chains (Fig. 3) 10. Mount the lift handle to the side of the right lift arm with (2) 3/8” x 1–1/2” bolts, a flat washer, (3) lock washers and (2) nuts. The hooks on the end of the chains have two attaching positions. One is for transporting and the other is for operating. 11. Secure the link end of each lift chain to the top of each lift arm with a 3/8” x 1–1/4” bolt, flat washer, lock washer and nut. Springs (Fig.
The Toro General Commercial Products Warranty A Two-Year Limited Warranty Conditions and Products Covered The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Commercial Product (“Product”) to be free from defects in materials or workmanship for two years or 1500 operational hours*, whichever occurs first.
