Service Manual

Gasoline Engine Page 3 - 8 GreensPro 1200

Figure 12

Figure 13

4. Place engine on frame. Secure engine using lock

nuts (16), cap screws (17), and flat washers (18).

Figure 14

5. Install rear support frame (19) using three lock nuts

(20), three cap screws (21), and six flat washers (22).

Figure 15

6. Connect the drive coupling to the engine collar

using two nuts (23), two washers (24), two cap screws

(25), and four spacers (26).

IMPORTANT: To prevent drive coupling damage,

make sure that no distortion of coupling exists

after securing engine collar to coupling. If coupler

distortion is evident, loosen engine and reposition

engine on frame so that coupling is not distorted.

7. Install and secure transmission cover (see

Transmission Cover in the Service and Repairs section

of Chapter 5 - Chassis).

8. Lower and secure the seat platform.

181716

20 21 22

24 25 2623