Service Manual

Hydraulic System Page 4 - 8 GreensPro 1200
Service and Repairs
Transmission
Removal
(Figures 2 through 7.)
1. Park machine on a clean, level surface with the
transport wheels in the raised and locked position.
Make sure engine is OFF. Remove spark plug wire
from the spark plug.
2. Move motion pedals to relieve system pressure.
3. Remove transmission cover from machine (see
Transmission Cover in the Service and Repairs section
of Chapter 5 - Chassis).
4. Drain oil from oil tank into a suitable container.
Figure 2
5. Thoroughly clean hose end and fittings on the
transmission assembly to prevent oil system
contamination.
6. Label all hoses and fittings for assembly purposes.
Remove hoses (1 and 2) from fittings on transmission
assembly. Drain hoses into a suitable container.
7. Put clean plugs in disconnected hoses and fittings
to prevent system contamination.
Figure 3
8. Remove nut (4), and disconnect damper (3).
9. Remove lock nut (5), cap screw (9), bushing (7),
and two flat washers (6), and disconnect linkage arm
(8).
Figure 4
10. Remove two lock nuts (10), two washers (11), two
cap screws (12), and four bushings (13).
1
2
3
4
5
7
6
8
6
9
10
11
12
13