Service Manual

GreensPro 1200 Page 4 - 9 Hydraulic System
Hydraulic
System
Figure 5
11. Remove lock nut (14), cap screw (15), and two flat
washers (16) at the bottom of the transmission.
12. Support the transmission.
Figure 6
13. Remove nut (20) and flat washer (21).
14. Remove lock nut (18), flat washer (17), cap screw
(24), flat washer (22), pivot bushing (25), two Oilite
®
bushings (26), and spacer (19), and remove idler arm
assembly (23).
Figure 7
15. Remove the retaining ring (31).
16. Remove three lock nuts (27), three cap screws
(28), and six flat washers (29), and pull transmission
(32) back until the two 8-tooth sprockets (30) are free of
the shaft.
17. Remove transmission (32).
14
15
16
20
21
23
19
24
22
17 18
25 26
32
31
30
27
28
29
27
28
29
27
28
29