Service Manual

Hydraulic System Page 4 - 12 GreensPro 1200

Figure 15

12. Remove plugs that were installed in hoses and

fittings during the removal process.

13. Using labels placed during removal, attach oil

hoses (29 and 30) to fittings on the transmission

assembly. Tighten hose swivel nuts to 24 lb-ft (32 N·m).

14. Adjust drive chain tension and lubricate chain.

(Refer to Operator's Manual.) Dri-Slide

Multi-Purpose

Lubricant (or equivalent) is recommended for chain

lubrication.

After drive chain adjustment, the drive chain should

have 0.200 in. to 0.300 in. (5 to 8 mm) deflection at

mid-span between sprockets.

15. Fill oil tank with new oil. (Refer to Operator’s

Manual.)

16. Install and secure transmission cover (see

Transmission Cover in the Service and Repairs section

of Chapter 5 - Chassis).

17. Lower and secure the seat platform.

18. Operate machine. Check oil level and adjust if

necessary. Check components for leaks. Tighten any

loose connections.

19.Raise machine onto transport wheels, check

transmission return to neutral setting and adjust as

necessary. (See HYDRO-GEAR BDR SERVICE AND

REPAIR MANUAL.)