Service Manual

GreensPro 1200 Page 5 - 9 Chassis
Chassis
5. Loosen jam nuts (7) of both steering head linkage
arms (8). Turn steering head linkage arms to achieve a
distance of 6.53 in. (166 mm) between centers of ball
joints (9). Do not tighten jam nuts until final step of
steering linkage adjustments procedure.
Figure 9
6. Using a suitable clamp (10), secure the frames of
both steering heads together, so that the heads are
parallel to each other. Place a straightedge (12) across
steering rollers (11) to ensure steering rollers are in
alignment. Adjust steering head linkage arms (8) (refer
to step 4) as necessary to achieve alignment.
Figure 10
Figure 11
7. Adjust steering head linkage arms (8) until spacers
(14) are flat against the steering disc (13). If the linkage
arms are incorrectly adjusted, the spacers will not be
flat against the steering disc (shown in Figure 10).
8. Remove block (2) from between steering pivot
assembly (3) and chassis frame (1).
Figure 12
9. Position steering wheel (15) square with machine.
10
12
11
14
13
14
~
Incorrect Linkage Arm Adjustment
13
14
~
Correct Linkage Arm Adjustment
15