Service Manual

GreensPro 1200 Page 5 - 11 Chassis

Chassis

Motion Pedal Adjustment

(Figures 14 and 15.)

1. Park machine on a clean, level surface with the

transport wheels in the raised and locked position.

Make sure engine is OFF. Remove spark plug wire

from spark plug.

Figure 14

2. Check motion pedal for correct adjustment by

placing a straightedge (1) across the top of motion

pedals (2). The straightedge should indicate that the

pedals are even with each other when correctly

adjusted.

Figure 15

3. If the straightedge determines that the pedals are

not even, adjustment of the linkage arm connected to

the transmission (3) is necessary.

4. To adjust linkage arm, remove transmission cover

from machine to gain access to transmission linkage

arm (see Transmission Cover in the Service and

Repairs section of this chapter).

NOTE: The linkage arm length should be

approximately 7.09 in. (180 mm) between the centers

of the ball joints (4).

5. Loosen jam nuts (5) on linkage arm (3) and then

adjust linkage arm length until the motion pedals are

even with each other.

6. Tighten jam nuts (5) when linkage arm length is

correct.

7. Install transmission cover and secure with cap

screw (see Transmission Cover in the Service and

Repairs section of this chapter).