Service Manual

GreensPro 1200 Page 5 - 13 Chassis
Chassis
Steering Tower
Removal
(Figures 17 through 25.)
1. Park machine on a clean, level surface with the
transport wheels in the raised and locked position.
Make sure engine is OFF. Remove spark plug wire
from spark plug.
2. Remove steering wheel (see Steering Wheel in this
section).
Figure 17
3. Remove six cap screws (1) and lock washers (2),
and remove column cover (3).
Figure 18
4. Remove two cap screws (6), four flat washers (7),
and two lock nuts (8) securing upper bearing assembly
(5) to steering column box (4).
5. Remove four cap screws (9), eight flat washers (10),
and four lock nuts (11). Remove steering column box
(4) from steering column (12).
Figure 19
NOTE: For assembly purposes, mark the location of
the upper bearing assembly (5) on the upper steering
shaft (13).
6. Loosen two socket head set screws (14), and
remove upper bearing assembly (5) from upper
steering shaft (13).
Figure 20
7. Remove four cap screws (15), eight flat washers
(16), and four lock nuts (17).
8. Remove two cap screws (18), four flat washers
(19), and two lock nuts (20), and remove steering
column (12) from chassis (21).
1
2
3
1
2
1
2
5
4
6 7 8
9 10 11
12
13
5
14
12
15 16 17
21
18 19 20