Service Manual

GreensPro 1200 Page 5 - 23 Chassis

Chassis

Installation

(Figures 48 through 51.)

Figure 48

1. Install cap screw (2) and flat washer (3) to roller

chassis (1).

Figure 49

2. If bushings were removed from steering disc (6),

press new Oilite

bushings (4) into steering disc (6).

Then insert pivot bushing (5) into installed Oilite

bushings (4).

3. Install steering spacer bushing (7) and then steering

disc assembly (6) onto cap screw.

Figure 50

4. Install plated washer (8) and lock nut (9) securing

steering disc (6) to chassis (1).

Figure 51

5. Secure front linkage arm (10), rear linkage arm (13),

and pivot rod (12) to steering disc assembly (11) (see

Steering Linkages in this section).

6. Lower machine to the ground.

7. Check steering operation and adjust steering

linkages if necessary (see Steering Linkage

adjustments in the Adjustments section of this

chapter).

2 3

8 9