Service Manual

Chassis Page 5 - 24 GreensPro 1200
Steering Head Assembly
NOTE: Refer to illustration of steering control assembly
(Figure 37) in this section when removing and servicing
the steering linkage assemblies.
Removal
(Figures 52 through 54.)
1. Park machine on a clean, level surface with the
transport wheels in the raised and locked position.
Make sure engine is OFF. Remove spark plug wire
from spark plug.
2. Using a suitable lifting device, raise and support the
machine.
Figure 52
CAUTION
3. Remove lock nut (3) and flat washer (4), and
disconnect tension spring (1) and anchor screw (2).
Figure 53
4. Remove lock nut (7), flat washer (9), lifting handle
bushing (10), cap screw (5), and linkage arm (6) from
steering head assembly (8).
5. Support the steering head assembly (8).
Figure 54
6. Remove four lock nuts (11), four cap screws (12),
and eight flat washers (13), and remove steering head
assembly (8).
Be careful when removing or installing spring.
The spring is under heavy load and may cause
personal injury.
1
2
43
7
10
6
9
5
8
8
131211
131211