Service Manual

GreensPro 1200 Page 5 - 27 Chassis

Chassis

Steering Rollers

Disassembly and Assembly

(Figure 59.)

Figure 59

1. Park machine on a clean, level surface with the

transport wheels in the raised and locked position.

Make sure engine is OFF. Remove spark plug wire

from spark plug.

2. Remove steering rollers from steering head

assembly. (See Steering Head Assembly in this

section.)

3. Remove and replace parts as necessary to repair

the steering rollers.

4. The bearing housing (3) is pressed into the steering

roller, and the bearing (2) is pressed into the bearing

housing. If bearing or bearing housing is removed from

steering roller, make sure that new components are

pressed fully into the roller during installation.

5. When installing lock nuts (1), tighten nuts equally on

both ends of the roller to allow free rotation of the

rollers. Do not overtighten lock nuts.

6. Install steering rollers in steering head assembly.

(See Steering Head Assembly in this section.)

1. Lock nut (2 used per roller assembly) 5. Roller spacer 9. Short steering axle

2. Bearing (4 used per roller assembly) 6. Short roller spacer 10. Long steering roller assembly (3 used)

3. Bearing housing (4 used per roller assembly) 7. Long steering roller (3 used) 11. Short steering roller assembly

4. Short steering roller 8. Long roller spacer (3 used) 12. Long steering axle